Sherwood R-945 Guide de dépannage télécharger pdf (Page 18)

Adjust the delay time.

Adjust the volume level of the rear speakers

relative to that of the front speakers.

Memorize the delay time.

󳀏Each time this button is pressed, the delay time

changes in regular intervals.

󳀏

If the delay time disappears, start from the step 14 again.

󳀏In Dolby Pro Logic mode, the rear delay time can be

memorized without pressing the DELAY TIME button.

In Dolby Digital(AC-3) mode, repeat the

above steps 15 and 16 to adjust the rear

delay time.

In THEATER, HALL, STADIUM or

CHURCH Mode

In Dolby Digital(AC-3), Dolby Pro Logic

mode, adjusting delay times of the speakers

󳀏When the distances from the prime listening

position to front left, center, front right and rear (left

and right) speakers are same, the basic settings are

as follows according to either the Dolby

Digital(AC-3) or the Dolby Pro Logic mode;

- In the Dolby Digital(AC-3) mode.

Center delay time : 0 ms, Rear delay time : 0 ms

- In the Dolby Pro Logic mode.

Rear delay time : 15 ms

󳀏If the center or the rear speaker(s) is(are) not at the

same distance from the prime listening position as

the front speakers, increase or decrease the center

delay time by 1 ms for every about 30 cm(1 foot) it

is closer or farther away and increase or decrease the

rear delay time by 5 ms for every about 1~1.5 m

(3~5 feet) it is closer or farther away.

REAR LEVEL

ENGLISH

• The delay time will be displayed for 5 seconds.

• Only in the Dolby Digital(AC-3) mode, the center

delay time can be adjusted and the corresponding

delay time is flickering.

Check the delay time to be

adjusted.

Cancel the test tone function.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Pas de commentaire

Sherwood R-945 Guide de dépannage Page 18