Sherwood R-807 Instructions d'exploitation télécharger pdf (Page 54)

R-807 NETWORK AV RECEIVER

NETWORK CONNECTION

Symptom Remedy

The main unit cannot

connect to the WPS via a

wireless LAN connection.

•

You cannot connect to a network using WPS when your access point is set to

WEP. Set up your network after searching the access point using the access

point scan.

The receiver cannot connect

to the network.

•

Check the network status.

•

When the system is connected through a wireless network, move the main unit

and the wireless LAN router/access point closer to each other and do the setup

again.

•

Check the settings of the wireless LAN router/access point and do the

setup again. For details on the settings of the devices, refer to the operating

instructions of the devices.

•

Make sure that you use a wireless LAN router/access point.

•

Wireless networks are inuenced by electromagnetic radiation emitted by

microwave ovens and other devices. Move the main unit away from these

devices

Cannot select the Network

Settings menu.

•

Wait for a few moments after you have turned on the main unit, and then select

the Network Settings menu again.

Important Information Regarding the HDMI Connection

Some HDMI signals cannot be routed through this system. (This depends on the HDMI-equipped component you are

connecting. Check with the manufacturer for HDMI compatibility information.)

If you cannot receive HDMI signals properly through the main unit (from your component), please try the following

conguration when connecting.

1 2 ... 49 50 51 52 53 54 55 56 57

Pas de commentaire

Sherwood R-807 Instructions d'exploitation Page 54