Sherwood R-807 Guide de dépannage télécharger pdf (Page 12)

ENGLISH

LOADING BATTERIES

OPERATING COMPONENTS WITH REMOTE CONTROL

REMOTE CONTROL OPERATION RANGE

• Use the remote control within a range of about 7 meters

(23 feet) and angles of up to 30 degrees aiming at the

remote sensor.

• When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries within several

minutes after removing old batteries.

• If the batteries are removed or have been exhausted for a longer period of time, memorized contents will be cleared.

Should this happen, you should memorize them again.

• Remove the batteries when they are not used for a long

time.

• Do not use the rechargeable batteries (Ni-Cd type).

• Be sure to use alkaline batteries.

1. Enter the setup code for each component other than

this receiver. For details, refer to “Entering a setup

code” on page 13.

2. Turn on the component you want to operate.

1. Remove the cover. 2. Load two batteries ("AAA" size, 1.5V) matching the

polarity.

3. Press the DEVICE button on the remote control

corresponding to the component you wish to operate.

4. Aim the remote control at the REMOTE SENSOR of

the component you wish to control and press the

button corresponding to the operation you want.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 34 35

Pas de commentaire

Sherwood R-807 Guide de dépannage Page 12