Sherwood R-772 Guide de dépannage

91. POWER SWITCHPush this switch to enter the standby mode.To switch the power off, push again this switch.2. POWER ON BUTTONIn the standby mode, when

10 LOADING BATTERIESREMOTE CONTROL OPERATION RANGE• Use the remote control unit within a range ofabout 7 meters (23 feet) and angles of up to 30d

11OperationsWhen the POWER ON button on the remote con-trol or the BAND button on the front panel ispressed, this unit is turned on to enter the oper

12orUPDOWN“MUTE” lights up.To resume the previous sound level, press this but-ton again.When adjusting the volume, the mutting effect isturned off.

Each time this button is pressed, the mode is displayed for several seconds and changes as follows : SPEAKER (TONE : ONBASSTREBLE) or BALANCE

14You can switch on or off the desired speakers.When adjusting the SPEAKER mode. A  B  A + B  OFF When adjusting the TONE mode.OFF : To

15Auto tuning• Each time this button is pressed, the band ischanged as follows : FM STEREO  FM MONO  AM (" " lights up) (

MEMORY BACKUP FUNCTIONThe following items, set before the receiver is turned off, are memorized.• INPUT SELECTOR settings• Preset stations,etc.• Tone

17• Use this function to automatically search and receive the stations offering RDS services.RDS (Radio Data System) is a method for sending informati

181. In the FM mode, press the SEARCH MODE button twice.PTY Search• Use this function to automatically search and receive the stations broadcasting th

19• Use this function to automatically search and receive the stations broadcasting the traffic program.• “TP Search” is displayed.• The tuner automat

20The audio signals from the desired input will be recorded onto the VIDEO.The volume, tone(bass, treble) and balance settings have no effect on the

21Each time this button is pressed, the brightness ofall fluorescent displays of this unit and SherwoodCD player such as CD-772, etc. connected by th

22Troubleshooting GuidePROBLEM POSSIBLE CAUSE REMEDYIf a fault occurs, run through the table below before taking your receiver for repair.If the fault

23 AMPLIFIER SECTIONPower output, stereo mode, 8 Ω, THD 0.08 %, 20 Hz~20 kHz ... 2X100 W

2ENGLISHIntroduction: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.This symbol is intended to alert t

3ENGLISHIntroductionREAD THIS BEFORE OPERATING YOUR UNIT ... 2System Connections

4System Connections• Do not plug the AC input cord into the wall AC outlet until all connections are completed.• Be sure to observe the color coding w

52. CONNECTING PHONO• The TV and AUX jacks may also be connected to an additional component such as a TV, DVD player, etc.• The TAPE IN/OUT jacks can

66. CONNECTING SPEAKERS• Usally SPEAKER A terminals are used for only a pair ofspeakers. When you have another pair of speakers,SPEAKER B terminals ca

77. SWITCHED AC OUTLET8. AC INPUT • This outlet is switched on (power-on mode) and off(standby mode) according to power control as follows(Maximum tot

8Front Panel & Remote Controls• You can remotely control not only this receiver but alsoSherwood compatible CD player.• For system remote co