Sherwood Scuba MAXIMUS SRB3600 regulator Spécifications télécharger pdf (Page 18)

4. Screw the orifice housing onto the threads of the lever assembly. Using a 3/4" wrench on

the orifice housing tighten them together snugly (70 in. lbs., 7.8nm).

5. Lubricate and install new o-rings & from the annual service kit onto the orifice housing

Note that the larger of the two o-rings goes on the end of the housing closest to the case.

6. Install the cover onto the case by sliding the retaining loop over the orifice housing. Since

the inner parts of the case have not yet been installed, the cover is rotated on the orifice

housing out of the way at this time.

7. Lightly lubricate the inner bore of the swivel fitting with the recommended grease. Install the

swivel fitting onto the orifice housing.

8. Install the retainer nut onto the orifice housing thread. Tighten the retainer nut snugly.

(70 in. lbs., 7.8 nm)

9. Install the cir-clip onto the orifice.

10. Install the adjusting knob onto the orifice.

11. Install the washer onto the screw . Place a small drop of locking adhesive onto the

threads of the screw, and install it snugly into the orifice using a size 0 square drive or Phillips

screwdriver.

12. If the old o-ring on the adjusting lever was replaced due to wear, lubricate and install a

new one onto the adjusting lever. If the o-ring is not worn, in can be lubricated in place on the

adjusting lever. Install the adjusting lever into the case . Using a small slotted screwdriver,

install the retainer clip onto the adjusting lever in its groove inside the case. Move the

adjusting lever through its full range. Check that the fins & move freely in the mouthtube

area. If they touch the top or bottom of the mouthtube and hang-up, rotate the lever support

slightly until the fins move freely. If the fins do not follow the adjusting lever tip through the

entire stroke, rebend the fins slightly to create the proper tension to keep them against the

lever tip.

THE FOLLOWING STEPS (13-19) ARE INCLUDED HERE FOR CONTINUITY. THEY MUST BE

PERFORMED AFTER THE REGULATOR SECOND STAGE IS ADJUSTED (see Section 5.4, Set-Up of

Second Stage).

13. Install the diaphragm into the case so that it sits evenly on the ledge.

14. Install the retaining ring into the diaphragm recess.

15. Work the cover over the case until it sits properly in its groove in the cover.

NOTE

: A drop of mild thread locker, such as Locktite 242® or equivalent should be applied to the threads

of the lever support to prevent the Orifice Housing from loosening during use.

NOTE

: Do not allow lubrication (grease on fingers, silicone overspray, etc.) to get on the case , the

diaphragm , the retaining ring , or the exhaust valve . This may cause these parts to slip or

deteriorate.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 28 29

Pas de commentaire

Sherwood Scuba MAXIMUS SRB3600 regulator Spécifications Page 18