Sherwood MAXIMUS SRB3600 Manuel d'utilisateur télécharger pdf (Page 25)

cleaner, isolate the orifice from the side walls and all other parts. Do this by placing the orifice

individually in a plastic cup in the cleaning hopper. This will help prevent mechanical damage

to the sealing surfaces of the orifice. Polish the orifice with a clean pencil eraser. Blow off dust

and debris after polishing.

5. Due to its unique stainless mesh design, the inlet filter of the Sherwood SR3601 first stage can

be cleaned in the ultrasonic cleaner. Visually inspect the filter before and after cleaning. Blow

the filter dry with clean compressed air.

6. Check the strength of any cleaning solution by placing a spare chrome-plated part in the bath

for a few minutes longer than the time you expect to leave the parts in. If visible damage to the

chrome finish results, then the solution is too strong.

7.3 COMMONLY USED CLEANING SOLUTIONS

SOLUTION COMMENTS

Soapy Water Good for plastic and silicone parts.

Vinegar and Water Ingredients easily available, 15

Equal part solution minutes approx. cleaning time.

1000 cc Water Fast acting solution that should be

60 gr. Sulfuric Acid made and used with care. Use

60 gr. Potassium Dichromate. gloves and safety glasses.

Cleaning solutions Usually the best route to go. Check

recommended by Ultrasonic with the manufacturer for strengths

Cleaner Manufacturers. and uses for their cleaners. Some

brand names of cleaning solutions

are "Branasonic

", "Micro

", "Oakite

", and "Brex

7.4 HANDLING TIPS

How your customers treat their regulators will directly influence the unit's function and

durability. Following are a few tips that you can pass on to your customers to help assure the

durability of their

Maximus SRB3600 regulator.

7.4.1 Pre-Dive Checks

1 Check the hoses and hose connections for cuts, abrasions or other signs of damage before

mounting the regulator on the tank valve. Slide the hose protectors back to inspect the areas of

the hose normally covered. Be sure all hose connections are tight.

2. Before turning on the tank air valve, check to make sure that the yoke nut or DIN connection is

tight and the regulator body is aligned properly, with no kinks in the hoses.

3. Turn the tank valve on

slowly and listen for leaks.

1 2 ... 20 21 22 23 24 25 26 27 28 29

Pas de commentaire

Sherwood MAXIMUS SRB3600 Manuel d'utilisateur Page 25